Let us bring your loudspeakers
back to life by giving them a full
"MOT" using our repair and
upgrade services. Price from -
£55.00 per pair inc. VAT
Why not replace your crumbling foam
fronts with tailor-made cloth covered
wooden grille frames
Let us help you design unique
bespoke cabinets for
Our cabinet-maker can produce
individually designed cabinets to a
high quality furniture finish.
20% Cancellation fee on
If you decide to cancel your
made-to-order speaker for any reason,
it is unlikely that we could sell it to
another customer at full selling price.
We will therefore charge a
cancellation fee of 20%
of the order price.
A demonstration room is available
at our premises for you to listen
to a selection of our loudspeakers.
You are welcome to bring your own
source equipment in order to replicate
your usual listening conditions
All major credit and debit cards
processed through secure SagePay
Monday to Thursday
8.30am - 4.30pm
8.30am - 1.00pm
Closed for lunch Monday - Thursday
1.00pm - 1.30pm
75mm Soft Dome Midrange (16ohm)
Exclusive to Wilmslow Audio, this version of Volt's renowned VM752 is the perfect successor to the now discontinued ATC SM75-150. Like the VM752, it is a classic 75mm diameter soft dome midrange loaded by a short front mounted horn. It uses a single layer round-wire copper coil, which is slightly longer than the focused magnet gap, to allow for excursions at the lower end of it's operating range.
The dome and double surrounds are critically doped for smoothness and consistency of response. The magnet system uses a 200mm ceramic magnet for high efficiency and is solidly fixed to a diecast aluminium chassis.
The VM753 requires rear mounting onto a 20mm (min) baffle board using M5 bolts into threaded inserts built into the chassis.
Sensitivity (2.83v/1m): 92.5dB
Nominal impedance: 16 ohm
Nominal power handling: 100w
Frequency range: 500Hz - 4000Hz
Free air resonance: 450Hz
Effective piston area (Sd): 57cm²
Excursion (lin-max): 4mm
Voice coil diameter: 75mm
Baffle thickness of 20mm is required to ensure horn mouth sits flush
Fixing holes: 4 x 5.5mm diameter on 172mm PCD
Cutout diameter: 154mm
Price per single unit excluding VAT